Proof that ADAS Calibration on Audi Q8 is correct comes from documentation, measurable verification, and final safety checks—not from warning lights alone. Begin with a pre-scan that records baseline DTCs and calibration status in all relevant ADAS modules. After completing static ADAS Calibration, dynamic ADAS Calibration, or both, a post-scan verifies that calibration-related faults are cleared and that module status reflects completion. Many routines also generate a calibration report or session record showing the procedure performed, the completion result, and the conditions required for success; saving this report supports warranty and reduces disputes if issues return. Strong verification for Audi Q8 also includes physical checks: confirm camera mounting integrity, bracket seating, sensor cleanliness, and proper trim and seal reinstallation. Ensure no conditions exist that would immediately retrigger calibration needs, such as misaligned components, obstructed sensor views, or unresolved alignment/ride-height issues. Where dynamic ADAS Calibration is required, confirm completion by status rather than assumptions based on time driven. Where static ADAS Calibration is required, tie completion to correct target setup and a successful routine result. If both methods are required on Audi Q8, retain documentation for both steps and perform a final status check after the combined workflow. A conservative functional check can then confirm stable lane recognition on clearly marked roads and normal behavior from adaptive cruise or forward-collision features where applicable, without turning the process into risky experimentation.