For a Panoz with a forward-facing ADAS camera, calibration is triggered by more than just the windshield. Any change that affects camera mounting, vehicle geometry, or how the system reads the roadway can push the camera out of specification. Windshield remove-and-replace is the most common trigger because the optical path runs through the glass and the bracket, gel pad, and fasteners must return to OEM tolerances. OEM procedures often require calibration if the camera is removed and reinstalled, the bracket is replaced, the mirror or camera cover is disturbed, or a windshield type is installed. Diagnostics can also force the workflow: camera, lane-keeping, adaptive cruise, forward collision warning, or automatic emergency braking DTCs may require calibration after repairs and code clearing. Mechanical changes matter too. Wheel alignment adjustments (toe or camber), steering angle sensor resets, ride-height changes, and suspension work like struts or control arms can alter the camera reference angle. After an impact, bumper or cowl work may create conditions where recalibration is recommended even if the windshield is intact. Rule of thumb: after windshield replacement or any of the changes above, confirm VIN-specific Panoz requirements before relying on ADAS. Bang AutoGlass supports the process with mobile service, next-day scheduling when available, insurance acceptance, and a lifetime workmanship warranty.